ATMOD – Jack Fuse - Quick Connect EOL Resistor Packs - 50 units, EOL Options

Jack Fuse SKU: ATMOD01

Item is available to order. Please note the estimated delivery times below (If not displayed please contact us). Please call to pre-arrange any pick-ups.
Select Resistance Pack: 1K/1K – Black

Please Note: Estimated delivery details below

Features Specs PDFs

Includes:

  • Quantity 50 per pack
  • Quick-connect, push-in terminals
  • Colour coded insulation
  • Pre-built PCB with surface mount resistors
  • Tab to indicate correct orientation
  • Rugged, insulated construction
  • Tiny size fits inside alarm devices, door frames and duct
  • EOL options - 1K/1K – Black , 2K/2K – Green, 4K7/4K7 – Yellow, 2K2/6K8 – Blue, 10K/10K – Red

Reduced labour cost is the major benefit of using the ATMOD. Installation time is cut
dramatically and zero time will be spent rectifying incorrectly installed or broken resistor
networks: NEVER GET EOL RESISTORS WRONG AGAIN. A new apprentice or other staff with
no experience can install the ATMOD quickly with little or no supervision and minimal tools.

Further labour savings can be made by fitting the ATMOD to field devices in the workshop
prior to going to site. Installation on site is then much more efficient; just terminate the
alarm cable directly to the ATMOD.

CONFIGURATIONS

  • Yellow – 4K7/4K7 Resistors
  • Red – 10K/10K Resistors
  • Green – 2K2/2K2 Resistors
  • Black – 1K/1K Resistors
  • Blue – 2K2/6K8 Resistors
  • White – 180Ω/300Ω Resistors

Termination
The ATMOD can easily be terminated to most types of alarm cabling, including multi core security cable and fly leads from reed switches, electric locks and exit buttons. Connections to devices without fly leads, such as a break glass unit, is as simple as taking a few seconds to strip short pieces of cable to act as fly leads between the ATMOD and any device with terminals.


The special high quality terminal blocks allow stripped wires to be pushed directly into the connector without the need for a terminal driver. A spring clamps the conductor making a sound connection that will outperform traditional methods especially in areas prone to movement or extremes of temperature as the spring clamp method imparts a constant ideal pressure on the conductor irrespective of wire size. Wires can be easily removed using a small terminal driver.


A small tab indicates the end of the ATMOD that should be connected to the alarm device. The ATMOD can be reused several times.

Technical Data

  • Minimum conductor size (Stranded) .2mm2 (24AWG)
  • Maximum conductor size .5mm2 (20AWG)
  • Dimensions 24 L X 7 W X 8 H (mm)

alliance wholesale prduct range

Newsletter

Sign up to receive the latest information